Versions Compared

Old Version 6

changes.mady.by.user Josune Cordoba (Unlicensed)

Saved on

compared with

New Version 7

changes.mady.by.user Josune Cordoba (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Start the interactive installer and follow its instructions:

    sudo sh ./opConfig-Linux-x86_64-4.0.0.run
    ...
    ++++++++++++++++++++++++++++++++++++++++++++++++++++++
    opConfig (4.0.0) Installation script
    ++++++++++++++++++++++++++++++++++++++++++++++++++++++
    ...
    This installer will install opConfig into /usr/local/omk.
    To select a different installation location please rerun the
    installer with the -t option.


  • The installer will interactively guide you through the steps of installing opConfig. Please make sure to read the on-screen prompts carefully. Also, a preconfigured file can be used. 
  • When the installer finishes, opConfig is installed into /usr/local/omk, and the default configuration files are in /usr/local/omk/conf, ready for your initial config adjustments.
  • A detailed log of the installation process is saved as /usr/local/omk/install.log, and subsequent upgrades or installations of other Opmantek products will add to that logfile.
  • For detailed information about the interactive installer please check the Opmantek Installer page.

...

If necessary the installer will offer to install MongoDB locally for you; if that is undesirable, or if you have a remote MongoDB installation that you want to use you'll need to adjust the MongoDB-related settings:
open conf/opCommon.nmis in an editor, go to the database section and change the server, username and password to reflect your MongoDB installation.
The result should look similar to the following (but there might be extra settings related to other products):

'database' => {
  'db_server' => 'localhost',
  'db_port' => '27017',
  'db_name' => 'nmis',
  'db_username' => 'opUserRW',
  'db_password' => 'op42flow42',
},

License

Access the opConfig GUI and acquire, restore or enter your license.
The opConfig GUI is accessible at http://<yourservername or ip address>/omk/opConfig/, and until you have entered a valid license neither the opConfig GUI nor the CLI tools will operate.

...

Please feel free to leave comments and suggestions below!

What's next? 

...

...