Table of Contents |
---|
...
- Smarter non-interactive installation with Preseeding
- Watch See poller nodes from the master.
- Fixed visualisation problem with numeric node nodes.
- Show poller_event_log if the NMIS9 is a master, in case we have configured syslog to get network events on master.
- Fixed node response time graphs for nodes.
...
- nmisng nodes now handle cluster_id on get_events_node: This is going to allow opHA to remove events from the poller on a peer deletion, so no data from the poller should remain. Also fix node_admin when dumping a node from the poller (Now will be able to get also event_data).
- Show message on delete node errors.
- Minor fixes ported from NMIS8:
- Added support for fping inter packet gap for some firewalls. New configuration options added: fastping_interval and fastping_target_interval.
- IPrevent NMIS from failing when an escalation event element is c:\\
- Adding the new opConfig "Node Configuration Change Detected event"
- Fixed newlines being included in WMI error messages
- Calling /proc/cpuinfo in the Support ZIP
- run-reports.pl makes sure the reports directory exists
- Optimisation to stop running services if no service polling required on a node
- work around net-snmp snmpd which reports almost anything as hrfixeddisk
- fixes for the Cisco Temperature model
- loadServiceStatus: A new parameter is added that allows filter by all clusters. This will allow opCharts to show Monitored Services from the poller.
- services.nmis: Added Opmantek.pl
- nmis-cli: On job type collect wasn't filter by local nodes.
- purge_op_status: Changed to 7 days by default.
- Display node name in opstatus.pl
NMIS 9.0.2
This beta release was published on 7 June 2019.
...