Skip to end of banner
Go to start of banner

Getting Started, Converting the OVF for VirtualBox

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

VirtualBox will import directly from an OVF/OVA file so you can just start up VirtualBox and select "Import Appliance..."

Browse to where you unzipped the file and select the ovf file

Select the file, you should see a screen something like this:


The import process may take a couple of minutes to complete, just enough time to grab a cup of coffee I'd say.If you have any trouble the VirtualBox documentation is here: https://www.virtualbox.org/manual/ch01.html#ovf

NOTE - The virtual machine is configured to use 8GB memory and the network interface may appear as NAT. Please revise the memory to suit and change the NAT adapter to Bridged.


Important Note regarding Ext4:

If your Virtualbox host is Linux and your VMs are stored on XFS or Ext4 file systems, then it is absolutely necessary that you enable the "Host I/O Cache" for all virtual disk controllers after importing the OVF file, or you run the risk of file system corruption in your guest. On one of our test systems (Linux kernel 3.14.23, Virtualbox 4.3.14) the VM wouldn't even fully get through the first boot before the virtual disks got corrupted - but with Host I/O Cache on everything is fine.

Below is an example of how to enable Host I/O Cache using VirtualBox:


Note - In some cases the system will log you out over and over due to the OVA by default having Automatic time synchronization enabled that may cause some authentication cookie issues. To avoid this issue simply check the "Hardware Clock in UTC Time" box in the settings menu under "System" before starting the appliance.


CentOS 7 on VirtualBox

It's now highly unlikely that VirtualBox users will find themselves at the dracut emergency shell prompt when first booting our vm that runs CentOS 7.
We continue to provide this information in case needed:

When faced with this obstacle reboot the vm selecting the rescue kernel. 


After it boots login as normal and try the try the following dacut command.  

dracut -f /boot/<kernel_image> <kernel_name>

 If the command completes successfully reboot the vm normally.  Be aware that future kernel updates may require this maneuver be done again.

  • No labels